Record curing processes – even in process!

DEA 230 Epsilon – Dielectric Analyzer

General Technique Software Applications Accessories Literature

Info & Service:

Product Information
Would you like to request more information on a particular product?
We will be happy to send you what you need.
Continue

Service Information
Find out more about our various service offerings.
We are at your assistance!
Continue

Sensors are available in a wide variety of configurations to meet the requirements of diverse applications. Below is an overview of the different implantable sensors and the robust, re-usable "Tool Mount Sensors" (TMS™) with comb structure or as monotrode for bulk measurements.

Implantable (disposable) sensors:

Integrated circuit (IC) chip sensor for low ion conductivity, for DEA 230/2 Epsilon only

Various flexible IDEX sensors (interdigitated electrode) for up to 200°C or up to 375°C

Special filtered IDEX sensors for carbon-fiber-reinforced resin systems

Various Micron sensors for thin layers (1 µm, 5 µm or 25 µm)

Sensors for high ion conductivity

Robust, reusable sensors and accessories:

Various Tool Mount Sensors (TMS™) with diameters of 0.5", 1" or 2" for up to 250 or 400°C for permanent mounting in a tool

Various Monotrode sensors with diameters of 6 mm, 0.5", 1" and 2" for up to 200, 250 or 400°C to be mounted in a mold (e.g. SMC/BMC)

"Dielectric Fluid State" (DFS) sensors for measurements in the fluid phase only

Pressure and vacuum-tight feed-throughs for autoclaves

We'll be happy to advise you on the optimum sensor for your application!

DEA furnace for all disposable sensors:

Every instrument in the DEA 230 Epsilon series can also be retrofitted with a small, easy to use lab furnace, which operates from room temperature to 375°C. Temperature/time ramps can be programmed with heating rates up to 40 K/min via the Eumetric software, making it possible to carry out practice-relevant experiments in the laboratory.

Press for prepregs:

For the compression of CFRP or GFRP prepregs we also offer, available immediately, a pneumatic, water-cooled press that delivers a force capacity of 10 kN at a pressure of 5 bar. Test molds up to a diameter of 165 mm with an integrated TMS sensor can be positioned therein. The press can be controlled for temperature ramps up to a maximum of 300°C either using the Eumetric software or manually.