Informação & Serviço:
Informação de Produto
Você gostaria de pedir alguma informação adicional sobre algum produto específico? Ficaremos felizes em lhe enviar o que você precisa.
 Continuar
Informação de Serviço
Consulte mais sobre nossas ofertas variadas de serviços. Estamos à sua disposição !
Continuar
The main advantage of light-curing systems is their fast reaction time. Monomer solutions which are mostly free of solvents can be cured within only a few seconds and already at low temperatures. A combination of thermal and light curing reactions is often applied to dual cure adhesives or paints.
software has been released.
The NETZSCH Photo-DSC 204 F1 Phoenix®, Differential Scanning Calorimeter, works in the temperature range from
-100°C to 200°C. The instrument has a gas-tight measuring cell and the purge gas control is regulated by a mass flow controller (MFC).
For our Photo-DSC 204 F1 Phoenix®, most standard industry or laboratory lamps for cationic or radically curing material systems can be used.
For adhesives, we recommend the DELOLUX04 high-pressure mercury lamp (315-500 nm), which can easily be triggered using the Proteus® software.
For paints and inks, we recommend the DSC be equipped with an OmniCure® S2000 lamp. The measurement parameters (e.g. exposure time and intensity) can be programmed and monitored by segment via the Proteus® software.
The luminous intensity of the high-pressure mercury lamp can be calibrated with the Radiometer R2000.
The modified automatic lid-lifting device of the DSC 204 F1 Phoenix® guarantees a defined distance between the two light conductors and the sample and reference.
This achieves high reproducibility of measurement results.
For your normal DSC analyses above 200°C, a retrofit of the standard lid-lifting device is possible, or the manual lid can also be used without problems.
For high sample throughput or for repeat measurements, use of our Automatic Sample Changer (ASC) for up to 64 samples is recommended. |
imprimir esta página
voltar ao topo
atrás
