GABOMETER

The Intelligent Universal Flexometer

Accurate measurements of Heat Build-up or Blow out processes and the determination of the thermal set can be realised by our GABOMETER® system – a development based on the established Goodrich Flexometer.

Both, force and elongation controlled tests can be carried out with this modern type of Flexometer. The GABOMETER® is suitable to improve the thermal dissipation and the durability of semi-finished tire components, dampers or absorbers.

Additionally, the new generation provides the measurement of the material stiffness (E modulus, tan δ - option) and damping.

Your Advantages

Your Advantages

  • Heat build-up and blow out tests according to Goodrich (DIN 53 533, ASTM D 623, ISO 4666/3,ISO 4666/4, BS 903 part A50 and JIS K 6265)
  • Goodrich flexometer tests
  • Static: strain or stress controlled load mode available
  • Dynamic: strain or stress controlled load mode available
  • Wide frequency range (option)
  • Wide temperature range (option)
  • Automatic Sample Changer (ASC) for fully automatic testing (24h) (option)
  • Simultaneous measurement of the visco-elastic properties (option)
  • Visco-elastic properties in DMTS/DMA mode (option)
  • Hysteresis analysis (option)
  • Pulse load mode available (option)
Key Technical Data

Key Technical Data

(subject to change)

  • Frequency range:
    30 Hz
    0.5 up to 50 Hz continuously (option, depending on model)
  • Static Strain Range:
    up to 60 mm
  • Dynamic Strain Range:
    ± 1.5 mm
    (optional up to ± 10 mm)
  • Force Range:
    up to 2500 N
  • Temperature Range:
    RT up to 300°C
  • Test Specimen size:
    Diameter: up to 30 mm (optional < 40 mm), depending on model
    Length: 25 mm
Accessories

Accessories

Sample Holder

Pair of insulated compression sample holders aimed for Flexometer tests equipped with a contact thermocouple for recording the sample temperature on the surface of the test specimen during Heat Build-up tests.

Recording of the sample “centre” temperature within the core of the test specimen during heat build-up tests with a needle type thermocouple (horizontal operation) manual mode (Option).

Automatic recording of the sample “centre” temperature within the core of the test specimen after heat build-up tests with a needle type thermocouple (vertical operation) driven by a pneumatic penetration system automatic mode (Option).

Special Compression Sample Holder

Automatic Sample Changer

Compression magazine for up to 50 compression testing specimens. A robot grip system takes the samples from the magazine and feeds the GABOMETER®.

Automatic Sample Changer

Downloads

You may also be interested in:

You may also be interested in:

DMA GABO EPLEXOR® Series up to 500 N

The testing instruments of the DMA GABO EPLEXOR® series up to ±500 N enable the dynamic mechanical (or static) characterization of a wide range of different materials including elastomers and polymers, composites, metals, glasses, ceramics, biomaterials and foods, adhesives, and liquids.

DMA GABO EPLEXOR® Ultra-High Force Series up to 6000 N

The floor-standing, modular, high-end NETZSCH DMA GABO EPLEXOR® series is specifically designed to determine the linear and non-linear viscoelastic behavior of materials which require measurements under very high force levels and/or large deformations.

DMA 242 E Artemis

The robust construction of the DMA 242 E Artemis and the high resolution of the deformation measuring system enable precise measurements on both very rigid and very soft samples. The most varied of deformation types, digital signal filtering, kinetic evaluation and frequency extrapolation make the DMA 242 E Artemis to a real all-rounder in the force range up to 24 N.