Non-destructive hot modulus: DMA analysis up to high temperatures

For ceramics, metals, alloys, glasses, composites and more

The DMA GABO EPLEXOR® HT line is the only instrument series on the market which is able to carry out DMA measurements with a maximum dynamic force of 500 N to 1500°C.

Two high-temperature furnaces are available: RT to 1000°C and RT to 1500°C. With a standard furnace (-160°C to 500°C) simultaneously mounted, it is possible to perform consecutive test runs in both the low- and high-temperature range. EPLEXOR® HT instruments can thus cover the entire temperature span from -160°C to 1500°C.

The electronics within the system automatically identify which furnace is currently in use.

The following DMA GABO EPLEXOR® HT are available:

Устройство является слишком маленьким, чтобы показать эту таблицу.
Instrument Type Max. Static Force Max. Dynamic Force *)
DMA GABO EPLEXOR® 25N HT 1500 N ± 25 N
DMA GABO EPLEXOR® 100N HT 1500 N ± 100 N
DMA GABO EPLEXOR® 150N HT 1500 N ± 150 N
DMA GABO EPLEXOR® 500N HT 1500 N ± 500 N

Key Technical Specificationis

(subject to change)

  • Temperature range:
    -160°C to 1500°C; the full temperature range can be covered if the instrument is equipped with the low-temperature and one high-temperature furnace 
  • Frequency range:
    0.01 to 100 Hz; optional: 0.0001 Hz; 200 Hz 
  • Static force range:
    max. 1500 N 
  • Dynamic force range:
    from ± 25 N up to ± 500 N (depending on instrument type, see table)  
  • Force sensor:
    interchangeable; nominal forces available from 10 N to 500 N (depending on the instrument type and configuration) 
  • Static displacement: 
    max. 60 mm
  • Dynamic amplitude:
    from ± 1.5 mm up to ± 6 mm (depending on the instrument type and system configuration)
  • Measurement modes for applications above 500°C:
    asymmetric and 3/4-point bending, compression
  • Work space of the high-temperature furnaces:
    cylindrical chamber, diameter: 70 mm, height: 120 mm

Downloads